Fire extinguisher cylinder hydraulic test stand is produced by our factory fire extinguisher pressure test the latest products, is based on user needs and production needs to adapt to fire, 
 Originally produced in our factory on the basis of the pressure test bench to further improve the R & D manufacturing. 
 Test pump: 
 Open the package and remove the test pump and the following accessories (power distribution boxes, electric contact pressure gauge, brochures, and random parts of a hose) 
 This machine uses the phase-wire installation, the machine is reciprocating piston pump, so there is no reversing of the motor points, fitted with electric contact pressure gauge, 
 To be added 10 × 1.5 "0" ring a tight, electrical box factory has been installed, the box on the two three-core cable is obviously marked 
 "Power Line" and "motor line" word mark, can be installed. 
 Test pump installed at this time. 
 Hydraulic test bench: 
 Open the package, remove the test stand and accessories (foot lifting plate, three fast pressure gauge, three fast connections, the appropriate fire extinguisher pressure test connector 
 Seal set, a small pipe) 
 1. The test stand tipped over, put foot down on the board. 
 2. Fitted with pressure gauge (to be placed in the junction 10 × 1.9 "0" ring tightening) 
 3. Extinguishers installed quick connectors and fittings, seals must also be added. (Al pad)